Address: Room B203, 85 Shatainan Road, Tianhe District, Guangzhou City, China
Die casting mold should pay attention to the following during operation
1. Use of mold cooling system. When the mold cooling water is accurately operated, it not only can extend the operating life of the mold, but also increase productivity. In actual production, we always have no importance. Even if we do the work, we omit the hand. It is very troublesome to receive it. Don't accept the cooling water pipe. A company is not so simple, but unexpectedly, it The use of cooling water saves the cost of custom molds and creates very serious side effects. Mold materials are typically used for special tool steels in a variety of processes, but each mold steel has limited performance properties, such as temperature. In the state of use of the mold, if the mold temperature is too high, cracks will occur prematurely on the surface of the mold core, and in some cases, the mold will be greatly cracked without exceeding 2000 molds. In addition, the color of the mold changes to the core of the mold, the temperature of the mold is too high, through the light, through the light, such temperature is also very cracked only in the cold state of the release agent, and the product comes out just deformed and applied it, And apply it and apply it to adhere and balance states like types. The use of mold cooling water can greatly enhance the use of die casting. This prevents the operator from using die casting to reduce the die casting temperature. Effectively extend the life of the mold, maintain the die-casting cycle, improve quality, and extend the adhesion of the adhesive, drawing and aluminum. The head and core losses can also be reduced due to the current at the mold temperature.
2. During the delivery process, the mold must be preheated, the crack of the turtle suddenly uses metal liquid to the mold to prevent cold, can be complicated in the mold, in more complex types, gas, hot molding machine in good condition, relatively simple mold Use slow pressure.
3. If the installation type is neutron control, then if the installation type is neutron control, then if you pay attention to the desk ban and the type of signal line terminal phenomenon, the reason is obvious, in the daily delivery, use the unavoidable signal Add water, or just break the recording area of the terminal and pick up the machine in a short time. If the signal is wrong, it will report automatically, work time, heavy signal interference, and harmful to large dust. Cause unnecessary losses. Be careful with the stroke switch for waterproofing.